
How to Write Limitations of a Study: Examples by Method
By Jessica McLaren 12 min read
To write the limitations of a study, name each constraint that affects how far your results can be trusted or generalised, explain what that constraint does to your findings, and say what you did to reduce it. Ross and Bibler Zaidi (2019) give the four parts every limitation needs: describe it, explain its implication, offer an alternative approach, and describe the steps you took to mitigate it.
Definition: limitations of a study. The limitations of a study are the constraints on how far its results can be generalised, applied or interpreted, usually arising from the design, the sample, the measures or events during the research. USC Libraries defines them as “the constraints placed on your ability to generalize from the results of your analysis.”
| Study type | Reporting guideline and item | What the item asks for |
|---|---|---|
| Randomised trial | CONSORT 2025, item 30 | Trial limitations: sources of potential bias, imprecision, generalisability and, if relevant, multiplicity of analyses |
| Observational study (cohort, case-control, cross-sectional) | STROBE, item 19 | Limitations, taking into account sources of potential bias or imprecision, and both the direction and the magnitude of any potential bias |
| Qualitative study | SRQR, “Limitations” | Problems or gaps in efforts to ensure trustworthiness, how the paradigm, approach and methods affect where the findings apply, and decisions or events that strengthened or weakened rigour |
| Systematic review | PRISMA 2020, items 23b and 23c | Two separate discussions: limitations of the evidence included in the review, and limitations of the review processes used |
| Any study (student thesis or paper) | Ross and Bibler Zaidi (2019) | Describe each limitation, explain its implication, give possible alternative approaches, describe steps taken to mitigate it |
Sources: CONSORT 2025 explanation and elaboration, BMJ 2025;389:e081124; STROBE item 19, EQUATOR Network; SRQR limitations item, EQUATOR Network; PRISMA 2020 checklist, EQUATOR Network; Ross and Bibler Zaidi, Perspectives on Medical Education 2019;8:261 to 264.
How do you write the limitations of a study, step by step?
You write the limitations of a study in four steps for each limitation: describe it, explain its implication, name an alternative approach, and say what you did to reduce it. Ross and Bibler Zaidi (2019) set out exactly these four parts and warn: “Too often, authors only list the potential limitations, without including these other important elements.”
- Describe the limitation in specific terms. Say where it came from: the study design, data collection, data analysis or the results (the four stages Ross and Bibler Zaidi sort limitations by). “The sample was small” is vague. “The sample was [number] participants from one [setting]” is specific.
- Explain what the limitation does to your findings. Name the threat. Ross and Bibler Zaidi give the model: “self-reported data may lead to inaccuracies (e.g. due to social desirability bias) which threatens internal validity.” For quantitative studies, STROBE item 19 asks for the likely direction and magnitude of any bias, so say whether the limitation probably inflated or shrank your estimate.
- Name an alternative approach. Say what design or method would have avoided the limitation, and why you could not use it (time, access, ethics, budget). USC Libraries suggests citing similar studies that faced the same constraint.
- Describe what you did to reduce the limitation. A sensitivity analysis, triangulation, a pilot, member checking, a second coder: whatever you actually did. If you did nothing, say what future research should do instead.
Steal this template (format illustration, fill in your own details):
This study [describe the limitation and where it came from]. This may have [direction of effect] the [finding or estimate], because [mechanism]. A [alternative design or method] would have avoided this, but was not feasible because [reason]. To reduce the effect, we [mitigation step]. Future studies could [recommendation].
What are examples of limitations by research method?
Examples of limitations differ by research method: surveys are limited by self-report, trials by blinding and generalisability, observational studies by confounding, qualitative studies by transferability, and reviews by the search itself. The table below pairs each method with limitation types drawn from the guidelines and from the USC Libraries list of methodological and researcher limitations.
| Method | Common limitation types | Example wording (fill in your own details) |
|---|---|---|
| Survey or questionnaire | Self-reported data, response rate, sampling frame | “Responses were self-reported, so [behaviour] may be over-reported because of social desirability bias, which would inflate [estimate].” |
| Randomised trial | Blinding, imprecision, generalisability, multiple analyses | “Participants could not be blinded to [intervention], which may have biased self-rated [outcome] in favour of the intervention group.” |
| Observational study | Confounding, measurement error, selection bias | “[Exposure] was measured once, so misclassification is likely; because this error was probably unrelated to [outcome], it would bias the association towards no effect.” |
| Qualitative interviews | Recruitment gaps, researcher position, transferability | “We were unable to recruit [group], so the findings may not transfer to [setting], where [reason the group differs].” |
| Systematic or literature review | Search limits (databases, language, dates), quality of included studies | “The search covered [databases] and English-language studies from [years], so relevant studies in other languages may have been missed.” |
| Case study or single site | Access, context-specific findings | “Data came from one [organisation], so [finding] reflects its [specific context] and should be tested in [other settings].” |
USC Libraries lists the usual methodological limitations as sample size, lack of reliable data, lack of prior research, the measure used and self-reported data, and the usual researcher limitations as access, longitudinal effects (the time available), cultural and other bias, and fluency in a language (USC Libraries, Limitations of the Study).
Ross and Bibler Zaidi (2019) warn that limitations are too often reduced to simplistic themes, and give three examples: “single institution study, use of self-reported data, or small sample size.” Use a stock limitation only if you can say how it changes your own result.
Where do the limitations go in a research paper or thesis?
The limitations usually go in the discussion section of a research paper or thesis, either at the start of the discussion or at the end, just before the recommendations for future research. USC Libraries gives both positions, and says limitations should not be buried in the middle of the discussion unless one is specific to something covered there, in which case it is repeated at the end of the section (USC Libraries).
| Document | Usual place for limitations | Source |
|---|---|---|
| Journal article (quantitative) | Discussion section | CONSORT 2025 item 30 and STROBE item 19 both sit under Discussion |
| Journal article (qualitative) | Results or Discussion | SRQR leaves the placement to authors and editors |
| Systematic review | Discussion, as two separate parts (evidence, then review process) | PRISMA 2020 items 23b and 23c |
| Thesis or dissertation | Discussion chapter, or the conclusion chapter before future research; check your department’s template | USC Libraries; local templates vary |
| Research proposal | Anticipated limitations, usually beside the methodology | Your university’s proposal template |
A research proposal has no results yet, so it states anticipated limitations and how you plan to reduce them, using the four parts from Ross and Bibler Zaidi (2019). Our guide on how to write a research proposal shows where the methodology section sits in a proposal.
How long should the limitations section be?
None of the main reporting guidelines (CONSORT 2025, STROBE, SRQR, PRISMA 2020) sets a word count for the limitations section. The length follows from how many limitations actually affect your results, with each one described, its implication explained, an alternative named and its mitigation stated.
Ross and Bibler Zaidi (2019) put the limit plainly: “Including redundant or irrelevant limitations is an ineffective use of the already limited word count.” USC Libraries gives the same advice from the other side: restrict the section to limitations related to the research problem, and describe each in “detailed but concise terms.”
In a thesis, a few limitations that change how a reader should interpret your findings, each in its own short paragraph, do more than ten one-line admissions. To see how many words your discussion chapter has to work with, the free dissertation word count calculator suggests chapter lengths from your total word limit (your handbook or supervisor overrides it).
Do limitations make your study look weak?
No. Stating the limitations of a study shows the reader you understand your own design, and reporting guidelines treat it as a required part of the paper. The SRQR guidance opens: “All research has limitations.” It adds that if you leave them out, editors and peer reviewers may ask about them, which will delay publication (EQUATOR Network).
The evidence suggests researchers under-report limitations, not over-report them. Ioannidis (2007) examined the first 50 articles published in 2005 in the six most-cited research journals and in two recently launched leading open-access journals, and found that only 67 articles (17%) used at least one word denoting limitations of the work presented, and only five had a separate section on limitations (Ioannidis, Journal of Clinical Epidemiology 2007). A clear limitations section puts your thesis ahead of that baseline, not behind it.
What does make a study look weak is apologising. USC Libraries advises: “Do not apologize for not addressing issues that you did not promise to investigate in the introduction of your paper.”
What mistakes should you avoid in a limitations section?
The most common mistakes in a limitations section are listing limitations without explaining their effect, using generic stock phrases, and including limitations that have nothing to do with the research problem. Ross and Bibler Zaidi (2019) name the first two directly: authors “only list the potential limitations” and “use generic descriptions to describe study limitations.”
- A list with no implications. “Small sample. Self-report. One site.” tells the reader nothing about your findings. Add the effect of each one.
- Generic wording. “This study has some limitations that should be considered” is filler. Name the limitation in the first sentence.
- Irrelevant limitations. USC Libraries advises restricting limitations to those related to the research problem.
- Apologising for scope you never promised. A boundary you chose on purpose (one country, one age group) is a delimitation. Say why you chose it in your methodology, not as a confession in your discussion.
- Limitations that contradict your methodology. Every limitation must match what your methodology section says you did.
What is the difference between limitations and delimitations?
Limitations are constraints you could not avoid that weaken your results; delimitations are boundaries you chose on purpose to keep the study manageable. A limitation belongs in the discussion with its effect on the findings, while a delimitation belongs in the introduction or methodology with your reason for drawing the line there.
| Aspect | Limitations | Delimitations |
|---|---|---|
| Who decides | Imposed by circumstances, design trade-offs or events | Chosen by the researcher |
| Example | Response rate lower than planned | Only final-year students at one faculty were invited |
| Where it goes | Discussion (or conclusion chapter) | Introduction or methodology (often “scope and delimitations”) |
| What you write | The constraint, its effect on results, alternatives, mitigation | The boundary and the reason for it |
USC Libraries’ definition gives the test: a limitation constrains “your ability to generalize from the results of your analysis.” A scoping decision is a delimitation first, and becomes a limitation only if it changes how far your findings apply.
How do you write limitations from your own papers with an AI assistant for writing backed by sources?
You write limitations from your own papers by checking how studies with a similar design admitted and handled the same constraints, then deciding which of those constraints apply to your study.
Litrevu is an AI assistant for writing backed by sources. It reads every paper, report and PDF you add, answers your questions with a citation to the exact passage behind each claim, compares sources side by side, and checks your own draft against them.
Here is how a student uses Litrevu at the limitations stage, using only the steps on how it works.
- Add the studies closest to your design. Upload the PDFs, or paste a PDF link, DOI or arXiv link, for the studies that used a method like yours. Litrevu can also find open-access papers on your topic for you to pick from.
- Ask what limitations those studies admit. Ask, for example, “What limitations do the authors of these studies report, and how did they reduce them?” Each answer is cited only from your papers, and when your papers do not cover a question, Litrevu says so.
- Open each citation. Every citation opens to the highlighted passage on the PDF page it came from, so you can read the authors’ own wording before you rely on it.
- Compare the studies side by side. Litrevu lines the studies up in a cited table, so you can see which limitation each study names (sample, measure, blinding, setting) and where they agree or differ. The free literature review matrix gives you the same columns to fill in by hand.
- Check your own limitations paragraph. Paste your draft and each claim comes back as Supported, Partly supported, Contradicted or Not in your papers. A sentence like “earlier studies also relied on self-reported data” comes back Supported only if one of your papers says so, with the passage to cite.
Format illustration (placeholder, not a real output): one row per paper, columns for design, sample and “limitations the authors report”, each cell cited as (Author, Year).
You still do the thinking: Litrevu lines up what your papers say, and you decide which limitations apply to your study and how to write them. “Not in your papers” means your library does not cover a claim, not that no study has reported it, so search wider before writing “no previous study has addressed this.” The check confirms a citation points to a passage in your papers, not that the passage fully supports your sentence, so read every cited passage. If you use any AI tool in your thesis, check your university’s policy and declare the use with the free AI disclosure statement generator.
Frequently asked questions
What are the limitations of a study?
The limitations of a study are the constraints on how far its results can be generalised, applied or interpreted. They usually come from the study design, the sample, the measures used, or events during data collection. USC Libraries defines them as “the constraints placed on your ability to generalize from the results of your analysis.”
How many limitations should I include in my thesis?
No reporting guideline sets a number of limitations. Include every limitation that changes how a reader should interpret your findings, and leave out the rest; Ross and Bibler Zaidi (2019) call redundant or irrelevant limitations “an ineffective use of the already limited word count.” For most theses that means a small number of limitations, each explained in its own paragraph.
Should limitations go in the discussion or the conclusion?
In a journal article, limitations go in the discussion: CONSORT 2025 item 30 and STROBE item 19 both sit under the Discussion heading. In a thesis, limitations go in the discussion chapter or in the conclusion chapter just before recommendations for future research, depending on your department’s template. USC Libraries suggests the start or the end of the discussion.
How do I write limitations in a research proposal?
In a research proposal, write anticipated limitations: the constraints your planned design will carry and how you will reduce them. Use the same four parts Ross and Bibler Zaidi (2019) recommend for a finished study: describe the limitation, explain its likely implication, name an alternative approach, and describe the mitigation you plan. Check your university’s proposal template for where the section goes.
Is a small sample size a limitation?
A small sample size is a limitation only when you explain what it does to your results, for example wider uncertainty around an estimate or too few participants to detect a difference. Ross and Bibler Zaidi (2019) list “small sample size” among the simplistic themes that limitations are too often reduced to. Say how small, why it was small, and how it affects the specific finding.
Where can I check my limitations against my own papers?
You can check your limitations paragraph against your own papers in Litrevu: add the studies closest to your design, compare the limitations their authors report in a cited table, and paste your paragraph to see which claims your papers support. Start with your papers in Litrevu. Free to start, no credit card required.